Acrylic finish-paste, 7 kg

The finish-paste acrylic PY200 TM "Professional" is designed for the finish leveling of walls and ceilings, plastered and other mineral surfaces, sealing cracks in plaster, brickwork and concrete basis. A homogeneous pastry putty PY200 is applied simply and quickly, forming a smooth, even surface. PY200 putty can be used directly from the bucket, requires only stirring and, if necessary, water dilution. With its help, alignment of surfaces, sealing seams and decoration of angles are performed quickly, easily and simple.

conditions for priming. The processed surface should be dry and clean, recommended surface and air temperature from +10 ° C to +35 ° C, relative humidity - 65 ± 5%.

surface preparation. The surface is cleaned of non -adhering old coatings, dust, dirt, fat and other substances that worsen adhesion (clutch). Before applying the finish-paste, it is imperative to primer the base of the PROFESSIONAL TM primer.

application. Mix putty thoroughly before use. In case of large surfaces of the surface, to use black plaster for alignment, and only, then, to the perfect state, to align the “finish-paste”. With the finish leveling of walls and ceilings, the material is distributed over the entire surface with a wide spatula or cell to perfect leveling. After drying and emphasis, a smooth surface is obtained. When putting down on small areas, with partial leveling, the material does not form cracks on the border of the applied putty.

consumption. 800-1000 g/m2, depending on the purpose of use and with a layer thickness of 1 mm.

drying time. Complete drying after 24 hours, at a temperature of +20 ± 2 ° C and relative humidity - 65 ± 5%. When atmospheric conditions change, drying time may increase.

storage and transportation. Store 18 months in a closed original package at a temperature of +5 ° C to +30 ° C, protecting from moisture, heat and direct sunlight. It can be transported by all types of transport at a temperature of -25 ° C for no more than one month, and the number of freezing/defrosting cycles should not exceed 5. When freezing products, thawing naturally in a warm room without a compulsory precaution. It is necessary to carry out work in a well -ventilated room using personal protective equipment for respiratory organs, vision and skin: glasses, gloves, respirator. If the material gets into the eyes, it is necessary to immediately rinse them with a large amount of water. If the material gets on the skin, remove it with a cotton swab and rinse the contaminated area with a plentiful amount of water. If necessary, consult a doctor. Protect from children.