Acrylic putty, facade, 1.5 kg

Acrylic facade ps602 TM "Professional" is used before the production of painting work to level the surfaces of the facades of buildings and interiors. PS602 putty is applied to concrete, brick, plaster, wood, chipboard, organite, drywall, asbestosenta. It has excellent plasticity and is perfectly polished after drying, which allows for high -quality surface preparation for further finishing: painting, gluing wallpaper, applying decorative coatings.

Conditions for priming. The processed surface should be dry and clean, recommended surface and air temperature from +5 ° C to +35 ° C, relative humidity - 65 ± 5%.

surface preparation. The surface is cleaned of non -adhering old coatings, dust, dirt, fat and other substances that worsen adhesion (clutch). Before applying the putty, be sure to primer the base of the PROFESSIONAL TM primer.

application. Acrylic facade PS602 Acrylic FASTENT FROM THE PREPART Carefully Mix. Before applying, it is recommended to primer the surface with a primer TM "Professional". Falling is applied by a spatula. The thickness of the layer is up to 3mm. The dried surface after clinging is ready for applying the desired coating. When applying a material with a thickness of more than 3 mm, when drying, the surface is drying. To eliminate this, it is necessary to apply a thin finish layer.

Consumption. 800-1000 g/m2, with a layer thickness of 1 mm.

drying time. Complete drying after 24 hours, at a temperature of +20 ± 2 ° C and relative humidity - 65 ± 5%. When atmospheric conditions change, drying time may increase.

storage and transportation. Store 18 months in a closed original package at a temperature of +5 ° C to +30 ° C, protecting from moisture, heat and direct sunlight. If the packaging has an additional “frost -resistant” label, transportation is allowed at a temperature of up to -25 ° C. When freezing the product, thawing at room temperature naturally. After thawing, the product retains all its properties.

precautions. It is necessary to carry out work on the street or in a well -ventilated room using personal protective equipment for respiratory organs, vision and skin: glasses, gloves, respirator. If the material gets into the eyes, it is necessary to immediately rinse them with a large amount of water. If the material gets on the skin, remove it with a cotton swab and rinse the contaminated area with a plentiful amount of water. If necessary, consult a doctor. Protect from children.