Acrylic putty for internal work, 3 kg

Acrylic putty for internal work PS601 TM "Professional" is used to seal cracks and align the surface. PS601 putty is applied to concrete, brick, plaster, wood, chipboard, organite, drywall. It has excellent plasticity and is perfectly polished after drying, which allows for high -quality surface preparation for further finishing: painting, gluing wallpaper, applying decorative coatings. When filling in deep cracks, after drying, it is allowed to crack putty PS601. It is necessary to go through the finish layer to eliminate.

conditions for priming. The processed surface should be dry and clean, recommended surface and air temperature from +5 ° C to +35 ° C, relative humidity - 65 ± 5%.

surface preparation. The surface is cleaned of non -adhering old coatings, dust, dirt, fat and other substances that worsen adhesion (clutch). Before applying the putty, be sure to primer the base of the PROFESSIONAL TM primer.

application. Mix putty thoroughly before use. Before applying, it is recommended to uninstall the surface with a deep penetration of TM "Professional". Application is carried out by a spatula. The layer of layers is up to 3 mm. The dried surface after clinging is ready for applying the desired coating.

Consumption. 800-1000 g/m2, with a layer thickness of 1 mm.

drying time. Complete drying after 24 hours, at a temperature of +20 ± 2 ° C and relative humidity - 65 ± 5%. When atmospheric conditions change, drying time may increase.

storage and transportation. Store 18 months in a closed original package at a temperature of +5 ° C to +30 ° C, protecting from moisture, heat and direct sunlight. If the packaging has an additional “frost -resistant” label, transportation is allowed at a temperature of up to -25 ° C. When freezing the product, thawing at room temperature naturally. After thawing, the product retains all its properties.

precautions. It is necessary to carry out work in a well -ventilated room using personal protective equipment for respiratory organs, vision and skin: glasses, gloves, respirator. If the material gets into the eyes, it is necessary to immediately rinse them with a large amount of water. If the material gets on the skin, remove it with a cotton swab and rinse the contaminated area with a plentiful amount of water. If necessary, consult a doctor. Protect from children.