Decorative coating "Manna", 7 kg

The decorative coating of the Manna TM "Elite-Décor" allows you to get a granular surface. Such a surface can be even as a snow field, or structural - “under a stone”. The coating relief, the depth of the drawing and the decorative effect depend on the artistic plan. It is used for decorative decoration of all types of surfaces made of concrete, brick, drywall panels, cement plaster and other mineral surfaces.

The conditions of application. The air temperature and the processed surface from +5 ° C to +35 ° C, humidity - 65 ± 5%. The base should be clean, dry and even, not to have inseparably holding and shaving areas. The prepared surface is treated with a primer “soil 500” TM “Elite-Decor” to strengthen and ensure a good fit to the covered surface (the use of soils of other manufacturers can lead to exfoliation of the material).

Preparation of color. The material can be applied in a tinted form. To obtain a given color, it is possible to apply the finish coating (paint, varnishes) tinted in the required color. Calamage is carried out with dyes or pigmented pastes. It is possible both industrial tinting and at home using an electric mixer. It is also possible to apply in an unshakable form, with further painting to the required color. It is recommended to tint all the necessary volume of the material at once.

application system. Mix the material thoroughly before applying. A basic, thin layer of “manna” is applied to the prepared surface (it is possible to apply a spatula, a cell, a trimmer, a roller). Immediately Kelma is introduced by the desired structure. Within 20-30 minutes, until the material began to dry out, the master has the opportunity to simulate the structure, texture, drawing. Immediately after completely drying, the surface is sanded, it is proposed to use a vibration grinder for this. Darerd possible dust. To give an additional decorative effect, it is necessary to cover the “azure” TM “Elite-DECOR” tinted in the desired color, which will provide a voluminous surface pattern. With large volumes, you can use the mechanical method of application using a hopper and compressor. In this case, the material is applied in a tinted form in one layer, and the relief “fur coat” will give the surface high operational characteristics resistant to wear.

Consumption. 2 kg/m2 (consumption depends on the desired effect, thickness of the layer and application method).

drying time. 24-72 hours, depending on the thickness of the layer and atmospheric conditions.

tool care. Immediately after the end of work with the material, rinse the tool with a large amount of water.

Storage and transportation. Store 24 months from the date of manufacture in a closed original package at a temperature of +5 ° C to +30 ° C, protecting from moisture, heat and direct sunlight. If the packaging has an additional “frost -resistant” label, transportation is allowed at a temperature of up to -25 ° C. When freezing the product, thawing at room temperature naturally. After thawing, the product retains all its properties.

Precautions. It is necessary to carry out work in the open air or in a well -ventilated room using personal protective equipment for respiratory organs, vision and skin: glasses, gloves, respirator. If the material gets into the eyes, it is necessary to immediately rinse them with a large amount of water. If the material gets on the skin, remove it with a cotton swab and rinse the contaminated area with a plentiful amount of water. If necessary, consult a doctor. Protect from children.

Composition. Acrylic latex, thickener, functional additives, fillers, water.