Decorative coating "Tornado", 15 kg

The decorative coating of the “Tornado” TM “Elite -Decor” allows you to achieve interesting design solutions: the randomly directed movement of the Master’s brush will create the effect of sand movement in nature, the unidirectional movement of the brush - sliding down the waterfall. It is used for decorative decoration of walls, ceilings and complex surfaces of cement and cement-lean of plaster, concrete, brick, asbestos-cement and drywall plates, chipboard, fiberboard and other similar surfaces.

The conditions of application. The air temperature and the processed surface from +5 ° C to +35 ° C, humidity - 65 ± 5%. The base should be perfectly smooth (the surfaces without a smooth structure must be treated with a spatula and polished) well dried, not to have inseparable and shabby areas, leveled using the “finish-paste” of TM “Professional”. The prepared surface is treated with a primer “soil-color” TM “Elite-DECOR” (the use of soils of other manufacturers can lead to exfoliation of the material) in the required color.

Preparation of color. The material can be applied in a tinted form. To obtain a given color, it is necessary to tint the substrate (“soil-color” TM “Elite-Decor”) into the color close to the desired color. Calamage is carried out with dyes or pigmented pastes. It is possible both industrial tinting and at home using an electric mixer. It is also possible to apply in an unshakable form, with further painting to the required color. It is recommended to tint all the necessary volume of the material at once.

application system. Mix the material thoroughly before applying. Apply a brush with natural bristles, without overloading the brush with material, areas of about 1-2 m2. Unidirectional or chaotic movements in different directions, evenly distributing the sand on the surface. After about 1-2 minutes with light movements of a dry hand, smoothing the surface, giving the coating the effect of a “sand whirlwind”. At the same time, softer strokes in different directions, remove possible irregularities left by passage of the brush.

Consumption. 0.2-0.35 kg/m2 (consumption depends on the desired effect, thickness of the layer and application method).

drying time. 24 hours, depending on the thickness of the layer and atmospheric conditions.

tool care. Immediately after the end of work with the material, rinse the tool with a large amount of water.

Storage and transportation. Store 24 months from the date of manufacture in a closed original package at a temperature of +5 ° C to +30 ° C, protecting from moisture, heat and direct sunlight. If the packaging has an additional “frost -resistant” label, transportation is allowed at a temperature of up to -25 ° C. When freezing the product, thawing at room temperature naturally. After thawing, the product retains all its properties.

Precautions. It is necessary to carry out work in a well -ventilated room using personal protective equipment for respiratory organs, vision and skin: glasses, gloves, respirator. If the material gets into the eyes, it is necessary to immediately rinse them with a large amount of water. If the material gets on the skin, remove it with a cotton swab and rinse the contaminated area with a plentiful amount of water. If necessary, consult a doctor. Protect from children.