Decorative plaster with a bark beetle effect 2mm 15.0 kg

Features:

• Ready to use decorative plaster of increased whiteness based on water acrylic dispersion with a characteristic structure in the form of grooves and grooves.
• forms a relief on the surface, resembling traces of a bark beetle on a tree trunk.
• creates a strong moisture -resistant, vapor -permeable coating, resistant to atmospheric influences and moderate operational loads.
• has excellent adhesion to the surfaces of concrete, stone, gypsum, cement, brick, chipboard, fiberboard.
• does not contain solvents, without smell.
• The size of the granules ~ 2 mm.
• allows washing the painted surface.

Scope:

for decorative surface decoration inside and outside the rooms.

surface preparation:

The surface should be dry, clean and durable. The exfused fragile layer should be removed. Slots, hollows and potholes to thumble. The dusty surface must be cleaned of dust and treated with the water -dispersion soil of Lacra. To improve adhesion of coating on smooth bases, as well as on chipboard and fiberboard, it is recommended to pre-apply 1-2 layers of special primer under decorative plaster. Apply at a temperature of at least 12 ° C and air humidity of more than 80%. Mix thoroughly before applying the plaster. Do not dilute. Apply evenly with a steel cell, removing the excess plaster (while the layer thickness should be approximately equal to the size of large granules ~ 2 mm). Decorative plaster can begin to be structured 10 minutes after application. Depending on the alleged structure, it should be evenly rubbed with plastic kelma with circular, vertical or chaotic movements. Open time for modeling the drawing - 20 minutes. The tool must be periodically washed. The cleaning of the tool is water. In order to avoid joints, large areas are processed in one pass by the product of one batch. It is optimal when one person applies and levels the plaster, and the other structures the coating. When processing by one person, apply the coating to a small area, structure, then move on to applying to the next fragment of the surface, working with the “wet in wet” method.

Storage:

Storage guarantee - 24 months from the date of manufacture. Store in the original tightly closed container at a temperature of 5 ° C to 35 ° C. It withstands 5 freezing cycles to minus 35 ° C. After defrosting at room temperature and thorough mixing, it restores consumer properties.

drying time:

at a temperature of 20 ° C and relative humidity 60%, 48 hours. A full set of strength is 10 days.

approximate expense:

2.0-3.0 kg/m2 (the thickness of the applied layer is 2 mm grain size).