Washing the cooling system LAVR Express, 310 ml

A two -phase composition for adding to antifreeze before replacing it.

dissolves and removes the scale and rust, coolant decomposition products and traces of oil that are formed during operation in liquid and combined cooling systems.

is used for cooling all types of gasoline and diesel engines cars.

One package is designed to flush the cooling system up to 10 l.

application:

1. Before use, warm the composition to room temperature and shake.

2. Cover with a rag a radiator lid or expansion tank and slowly open it, dropping the pressure of the system. Only after that you can open it completely.

3. Pour the composition into a radiator or expansion tank (in the case of a completely closed radiator) at the rate of 310 ml of the cleaner per 10 liters of coolant.

4. Run and warm the engine to operating temperature (+80 ─ 90 ° C). Let him work 30 minutes at idle. All this time, the cabin heater should be turned on at the maximum heating.

5. Dive and cool the engine.

6. Drain the flushing solution. Under the radiator, put a container for collecting the old coolant and flushing solution. Turning the drain plugs, drain the antifreeze in turn from the engine and radiator.

7. Rinse the cooling system until the remnants of the flushing fluid are completely washed out: pour distilled or clean warm water, warm the engine (wait for the opening of the thermostat, in which the radiator leading and diverting the ropes will be hot) and let it work 10 ─ 15 minutes at idle, drain the water. If necessary, repeat the procedure.

8. Install drain plugs and pour a new cooling liquid into the system.

Attention!

In order to avoid the release of antifreeze and a flushing solution of drain of liquids from the system, to produce no higher than +80 ° C at an engine temperature! The boiling liquid will lead to an instant emission to the outburst of a toxic chemical, which, in addition to indispensable burns, will lead to poisonous vapor entering the body.