Active oxygen oxygen for water treatment in the pool, 5 kg

Purpose:

"free" water treatment with the effect of disinfection + protection against algae. The product acts against a wide range of bacteria, viruses and mushrooms; It can be used in pools with anti-flows, fountains, geysers, in SPA basins; It can be used in combination with other water processing systems based on the “active oxygen” method.

application:

before processing the water “Oxystes”, it is necessary to “reverse” the filter flushing and check level of pH. If the water contains active chlorine, it is necessary to dechloit water using the Aquadekhlor tool.

is dosed into the water of the pool using an automatic system.

in the absence of an automatic metering station, it is recommended to dissolve the product in water In a separate plastic container, lowering the initial concentration of 5-10 times, and then add the resulting solution to the pool water near the water supply (triska) or in several places around the perimeter of the pool (but not before the filters!) During the operation of the pump. < /p>

Important! The Okvestus tool is not compatible with chlorine and other oxidizing agents!

the consumption of the product:

in accordance with the content of the carrier of active oxygen in the water of the pool. This indicator must be constantly maintained within 5 to 8 mg/l (measured using a tester on “active

oxygen”).

Recommended dosages for 10 m 'water (with manual transmission ):

• Current processing: 0.5l every 5-7 days with continuous filtration (at least 8 hours). With intensive use of the pool, bright lighting and/or high temperatures, you should increase the dosage and/or processing frequency in accordance with the indicator of the level of “active oxygen” in the water of the pool.
  • “shock” processing: 1l with continuous filtration (at least 8 hours).

  in case of increased turbidity caused by organic pollution and algae, the dose can be increased up to 2l. At the same time, a technical break is required in the operation of the pool (at least 12 hours) with continuous filtering;

  then rinse the filter thoroughly.

  Composition:

  colorless transparent fluid; Contains hydrogen peroxide (at least 35% on the date of manufacture), cationic polymers.