Bearing the engine LAVR ML-202 Set, 330 ml LN2504

How to reduce oil consumption and return the engine power? The legendary shift of the LAVR ML202 this task is on the shoulder. LAVR ML202 is a bestseller among the bloomers in Russia and the countries of the Near Abroad. Over 20 years, LAVR ML202 chose more than 3,500,000 buyers. The classic formula for liquid excavation LAVR ML 202 frees the fallen piston rings well. It effectively eliminates a decline in compression within 10-20% of the norm, oil and butter, reduction of power and engine receiving. Depending on the resistance of the resin-croken deposits, the exposure time can fluctuate from 1 to 12 hours.

You definitely need a splitting if:

• Power is lost
• The acceptance and dynamics of
• the machine began to smoke
• You spend a lot of time in traffic jams

The tool eliminates varnish and pile with:

• piston of the piston
• compression rings
• oilflowing ring
• oil -outing channels

is absolutely safe for All types of piston coatings and walls of cylinders, catalysts, paint of the crankcase pallet.

The ml202 engine shift is suitable both for independent use and as a service tool.

• for better exposure Warm up the engine to the operating temperature (not lower than 70 ° C).

Disconnect the ignition system (for example, disconnect the ignition coil terminal). This will prevent the failure of the high -voltage part of the ignition system and the possible ignition of the vapor of the drug.

for a gasoline engine - dismantle the spark plugs. For diesel - an incandescent candles or nozzle.

• put the pistons in a position close to the middle, turning the crankshaft by the pulley mounting or using the drive wheel when the drive is turned on (on cars with a mechanical gearbox). You can determine the positions of the pistons through the technological holes with a long probe.
• evenly distribute the liquid through the cylinders using an extension tube. Close the technological holes for the formation of a “steam bath” in the combustion chambers - for example, screw the candles into several turns.
• leave the split for exposure: for preventive cleaning for 1 hour, with a significant hairpin up to 12 hours. It is recommended to periodically slightly move the pistons up and down to better penetration of the composition.
• Free the technological holes, remove the liquid from the combustion chambers with a syringe with an extension tube as much as possible and blow the cylinders with compressed air. Close the technological holes with a dense fabric again, completely squeeze the accelerator pedal and scroll the engine shaft by the starter 2 - 3 times 5 seconds.
• Install the dismantled nodes and details, make sure the assembly correctness.
• for It is recommended to drive the first 5 to 10 km with slightly high speed rings and the removal of soils and the removal of soils.

use with caution to disconnect engines with maximum wear and highly contaminated lubrication system.