Bearing the engine LAVR ML203 Truck, 1 liter

The ML203 Truck engine is an enhanced composition for commercial vehicles and cars with a large engine volume.

Due to the high penetrating ability, the ML203 softens and removes persistent deposits on the pistons, compression and oil -removable rings in one hour.

normalizes the oil consumption, evens out compression in the cylinders, restores the traction-speed characteristics of the engine.

ml203 Truck is safe for paint of the Carter pallet, subject to the instructions.

Recommended for cars with great mileage and serious problems of hair clipping.

is suitable for all types of gasoline and diesel engines.

The packaging is designed to separate the engine with a volume of 6000 - 12000 cm³.

Application:

1. Warm up the engine to the operating temperature (at least 70 ° C).

2. Disconnect the ignition system. This will prevent the failure of the high -voltage part of the ignition system.

3. For a gasoline engine - dismantle the spark plugs. For diesel - glow candles or nozzles.

4. Put the pistons in a position close to the average.

5. Pour the equal amount of liquid, in accordance with the instructions, into each cylinder and close the technological holes for the formation of a “steam bath” in the combustion chambers.

6. Leave for 30 minutes to influence. To clean the heavily chopped engines, increase the exposure time to 60 minutes. Do not exceed the recommended exposure time and reduce the interval as much as possible to the oil replacement to maintain the integrity of the LCP of the Carter pallet.

7. Free the technological holes, remove the remaining fluids and blow the cylinders with compressed air (up to 3 bar). Cover the technological holes with a dense fabric to avoid spraying the remains of the composition. Squeeze the accelerator pedal completely and scroll the engine shaft by the starter 2 - 3 times for 5 seconds.

8. Remove the spent oil from the engine as fully as possible using the most effective way for your car.

9. Replace the oil filter and pour new oil.

10. Set the dismantled nodes and parts, make sure the assembly correctness.

11. After cleaning, the first 5-10 kilometers do not load the engine with large speeds.

it is recommended to disconnect the engine every 20-25 thousand kilometers when passing the planned TO.

the drug can be used as a diagnostic tool to assess the actual state of the cylinder-piston group.

use with caution for the disconnection of engines with maximum wear and a strongly contaminated lubrication system.