Bearing the engine Lavr Ml204, 190 ml

The ML204 engine is a powerful engine cleaning, created as an alternative to overhaul.

has maximum cleansing properties and penetrating ability.

In just one hour, softens persistent deposits in the cylinders and restores the mobility of completely lounging piston rings.

As a result, the consumption of oil and fuel decreases, power and dynamics increase, compression is aligned.

ML204 is recommended for use in cars with high mileage, after prolonged downtime or with serious malfunctions of the power unit.

Suitable for all types of gasoline and diesel engines.

Application:

1. For better exposure to the composition, warm the engine to the operating temperature (not lower than 70 ° C).

2. Disconnect the ignition system (for example, disconnect the ignition coil terminal). This will prevent the failure of the high -voltage part of the ignition system and the possible ignition of the vapor of the drug.

3. For a gasoline engine - dismantle the spark plugs. For diesel - candles or nozzles.

4. Put the pistons in a position close to the middle, turning the crankshaft over the pulley mounting nut or using the drive wheel when the gear is turned on (on cars with a mechanical gearbox). You can determine the positions of the pistons through the technological holes with a long probe.

5. Drain the oil from the engine into a clean container (in the future it will be used to flush the engine) and dismantle the card of the crankcase.

6. Using a syringe with an extension tube, pour the equal amount of liquid into each cylinder.

7. Close the technological holes (for example, screw the spark plugs into several turns) to form a “steam bath” in combustion chambers.

8. Leave the split for exposure to 60 minutes. It is recommended to periodically slightly move the pistons up and down to better penetration of the composition.

9. If after this period a large amount of fluid remains in the cylinders, an increase in exposure time is allowed to 90 minutes.

10. Free the technological holes, remove the liquid from the combustion chambers with a syringe with an extension tube and clean cloth with a drift with a trace of the engine and the engine walls from traces of the purifying liquid.

11. Perform the process of blowing the cylinders with compressed air (up to 4 atm.)

12. Set the Carter pallet.

13. Pour the previously merged motor oil into the engine.

14. Perform the cylinder purge procedure: cover the technological holes with a dense fabric to avoid spraying the composition. Squeeze the accelerator pedal completely and scroll the engine shaft by the starter 1-2 times 5 seconds.

15. Set the dismantled nodes and parts. Make sure the assembly correctness.

16. Run the engine and warm it to the operating temperature.

17. Cut the engine and remove the spent oil from the engine as fully as possible using the most effective way for your car.

18. Replace the oil filter and pour new oil

19. After cleaning, the first 10-20 kilometers do not load the engine with high speeds.

Avoid the composition of the composition on the paintwork.

Use with caution for the disconnecting of engines with maximum wear and a highly contaminated lubrication system.

Attention !!! On engines with a volume of more than 2,000 cm, it is recommended to disconnect the fuel supply system, since when the engine starts up with an on the power system, the fuel pair can be ignited in the resonator.