Emal Acrylic Universal, Super Lingension ES-210, 1 kg

Acrylic enamel super gloss ES-210 is used for the most important work, both indoors and outside. Thanks to its composition, namely, imported raw materials components, it is always stable high quality.

Snowty color allows you to obtain pure pastel colors when tinted. After drying, it forms a super -glossy coating with an abrasion cycle of more than 10,000.

purpose. The super -glossy enamel is designed for external and internal work on concrete, brick, plastered, wooden, and other grounds. The enamel has good spreading, which makes it possible to high -quality staining of wooden surfaces. It is recommended to use on surfaces subjected to increased operational loads, it is possible to use radiators, water heating pipes and water supply for the finish staining. After drying, it forms a smooth, elastic, super -glossy, stubborn film.

Recommendations for use. The product is completely ready for use. Before applying the enamel, it is necessary to prepare the surface responsibly. The base should be clean, durable, dry, cleaned of dust, dirt, from the exfoliated and obscure old paint, if necessary, degreased. It is recommended to cover the surface with a primer TM “Veme”, which will strengthen the surface, will give it excellent surface-combating properties. Before applying, the enamel is thoroughly mixed (a slight stratification of enamel is allowed). Apply with a brush, roller or spray gun. To reduce the viscosity of enamel when stained from a spray gun, it is allowed to dilute the deep penetration of TM “Veme”, but no more than 5%. The air temperature and the processed surface is from +5 ° C to +35 ° C. The relative humidity is 65 ± 5%.

Consumption. 150 - 250 g/m², depends on the absorption of the base, as well as on the quality of its preparation.

drying time. For casting - 3 hours. A two -layer application is recommended, with drying between layers - 12 hours. Complete drying after 24 hours. The process of complete polymerization of the film and the achievement of maximum indexism in abrasion ends on average after 28 days.

tinting. The enamel can be stunned in any color according to any tinting system. Exceptions are 100% saturated colors, the maximum percentage of pigment input should not exceed 10% of the enamel volume. In case of violation of this proportion, the enamel will lose its qualitative characteristics.

storage. In a closed original package at a temperature of +5 ° C to +30 ° C.

Transportation. In a closed original package at a temperature of +5 ° C to +30 ° C. If the packaging has an additional “frost -resistant” label, transportation is allowed at a temperature of up to -25 ° C. When freezing the product, thawing at room temperature naturally. After thawing, the product retains all its properties. In frost -resistant enamel, drying time can increase: for a cast - 12 hours, a complete drying of an average of 48 hours, but it can take more time.

Precautions. Work on coloring must be carried out in the open air, or in a well -ventilated room using personal protective equipment for respiratory organs, vision and skin: glasses, gloves, and respirator. If the material gets into the eyes, it is necessary to immediately rinse them with a large amount of water. When enamel gets on the skin, remove it with a cotton swab and rinse the contaminated area abundantly with water. If necessary, consult a doctor. Protect from children.