Riding the engine Lavr Ml202, 190 ml

The engine of the engine ML202-classic liquid formula for the disconnecting of the cylinder-piston group. The composition is suitable for cleaning all types of gasoline and diesel engines, which for the first time or recently diagnosed symptoms of hair sections. It has a high penetrating ability and gentle effects: after applying this shift, the engine can be operated at increased speeds. Effectively eliminates problems such as the average overspending of oil, reduction of power, deterioration of dynamics and acceptance, increased fuel consumption, compression difference in cylinders. The product is recommended for use for regular operation in urban traffic. The exposure time varies depending on the degree of engine pollution to 12 hours without risk to damage rubber seals, the paint of the crankcase and the antifriction coatings of the cylinders.

Advantages:

• The ML202 engine shift is suitable for use in gasoline and diesel engines of any type.
• is used at the first signs of hair selection
• reproaches compressive and oil -shooting rings
• Restores compression in case of deviation from the norm of 15 - 20%
• recommended for oil consumption up to 100 ml per 1000 km of run on atmospheric engines and up to 500 ml per 1000 km on turbocharged engines
• Reduces the consumption of oil and fuel
• exposure time from 1 to 12 hours
• produced packaging are designed for engines with a volume of up to 2.0 l
• does not require removal of the gap of the crankcase
• The procedure is carried out with mandatory oil change
• The kit includes detailed instructions for the use of shifts, an extension tube and a syringe

application:

• For the best effect of the drug, warm the engine to the operating temperature (at least 70 ° C). This will prevent the failure of the high-voltage part of the ignition system and the possible ignition of the vapor of the drug.
• for a gasoline engine-to dede the spark plugs. For diesel -vapibation or nozzles.
• put the pistons in a position close to the middle, turning the crankshaft by the pulley mounting nut, or using the drive wheel when the drive is turned on (on cars with a mechanical gearbox). You can determine the positions of the pistons through the technological holes with a long probe.
• Using a syringe with an extension pipe, pour the equal amount of liquid into each cylinder. Close the technological holes (for example, screw the spark plugs into several turns) to form a “steam bath” in combustion chambers.
• For preventive cleaning, withstand 1 hour. With significant lawsing, increase the exposure time of the drug to 12 hours. In order for the liquid to seep better into the area of ​​the piston rings, it is recommended to turn the crankshaft for 1-2 turns every 10-15 minutes.
• free the technological holes. Remove the remaining liquid with a syringe with an extension tube and blow the cylinders with compressed air. Cover the technological holes with a dense fabric to avoid spraying the remains of the drug. Fully squeeze the accelerator pedal and scroll at the engine shaft by the starter 2-3 times 5 seconds.
• when the engine starts with the power system is scrollful, fuel is supplied to the cylinders, the pairs of which can accumulate in the exhaust system and cause fuel ignition in The resonator when starting the engine. Therefore, on engines with a volume of more than 2000 cm, it is recommended to disconnect the fuel supply system.
• install dismantled nodes and parts. Make sure the assembly correctness.
• Run the engine and let it work at idle for several minutes until the operating temperature reaches. It is possible to smoke short-term smoke due to the burning out of the remnants of the drug and deposits, non-hazardous for catalysts.

to be careful with care for the disconnection of engines with maximum wear and a highly contaminated lubrication system.

Attention! The composition does not restore the details and does not compensate for the wear of the engine! Note: In cases where the car engine is inclined, the V-shaped, opposite or combustion chamber is formed by a significant excavation in the piston, the amount of composition should be increased.