Smart gypsum Samaragips Facade XXL, 1 kg, moisture -resistant

Scope:

is used for the manufacture of decorative elements for external facade decoration.

Preparation of the solution and work procedure:

• Dry the mixture to clog a clean mixture clean water at room temperature (no more than +30 ° C) according to the principle of “mixture into water” in the ratio of 1 kg of dry mixture 0.26-0.3 l of water;
• mix the mixture with a construction mixer or a drill with a nozzle with a drill At least 2-3 minutes until a homogeneous mass is obtained;
• , when using dry pigments, mix them with water. Pour the resulting solution in the form;
• remove the excess of the mixture with a spatula;
• , subject to the recommendations of the manufacturer, the liner is possible after 45-60 minutes;
• the lifting of forms depends on the quantity and The qualities of the used water (for the preparation of mortar mixtures are used by GOST 23732), as well as temperatures (20 ± 2 ° C) and relative humidity in the room (60 ± 10%);
• with the complete drying of the products, the color of the painted color The stone becomes lighter for several tones;
• when using pigments of another chemical nature, it is recommended to check the interaction on a small amount of the mixture.

Recommendations for the installation and operation of decorative elements:

use only pure tools and containers!

• The geometric dimensions of the finished decorative elements should not exceed the following parameters:
  • length - 1000 mm;
  • width-200 mm;
  • thickness-20-50 mm.
• The installation of decorative elements is made no earlier than 7 days after its manufacture; < /li>
• storage of manufactured decorative elements is carried out at a temperature of 20 ± 2 ° C and relative humidity in the room (60 ± 10%);
• for the installation of decorative elements, it is recommended to use the Superfix Fasad cement glue designed for this type of work;
• manufactured and mounted decorative elements should not be exposed to prolonged water exposure;
• to prevent the effects of atmospheric precipitation, decorative elements are recommended to be covered with moisture -repellent compositions (hydrophobizers, impregnations, silicone, varnishes. on a wax or paraffin basis).

Technical characteristics:

• Color - white (shades are possible);
• 1 water consumption per 1 kg of dry mixture - 0.26-0.3 l;
• The deadlines for grasping the mortar mixture - the beginning of grasping - no earlier than 15 minutes, the end of the grasp - no later than 45 minutes;
• consumption of the material - 17 kg/m2 (with a product thickness of 10 mm);
• the area of ​​the product from one bag is 1.5 m/2 (with a product thickness of 10 mm);
• compression strength for compression After 28 days - at least 45 MPa;
• frost resistance - at least 150 cycles.

*All of the above characteristics are fair at a temperature (20 ± 2 ° C) and relative moisture in the room (60 ± 10%).