Soil-concentrate "Moogo-insulator", 1: 5, for internal work, 1 liter

The soil-concentrate moisture insulator 1: 5 for internal operations PG112 TM "Professional" is unlawed for moisture insulation of concrete walls, brick masonry, gypsum plastic panels, cement plaster, other mineral and wooden surfaces. The soil-concentrate is designed for use in rooms with high humidity: bathrooms, bathrooms, basements and technical rooms. In diluted form, it is used as a high -quality primer for internal work.

conditions for priming. The processed surface should be dry and clean, recommended surface and air temperature from +5 ° C to +35 ° C, relative humidity - 65 ± 5%.

surface preparation. Clean the surface of obscure old coatings, dust, dirt, fat and other substances that worsen adhesion (clutch).

application. Mix the primer carefully before use. Apply with a brush or roller, in diluted form it is possible to apply a spray gun. In most cases, one layer is enough. For strongly absorbent surfaces, at least two layers are recommended. For moisture insulation, the concentrate cannot be diluted. For responsible surfaces, dilute in a ratio of 1: 1, strongly absorbing - 1: 3, poorly absorb - 1: 4, for priming under the pasting with wallpaper - 1: 5.

consumption. 100-250 ml/m2 of the finished composition, depending on the method of application and the absorption of the base.

drying time. From dust - 0.5 hours. Complete drying after 2 hours, at a temperature of +20 ± 2 ° C and relative humidity - 65 ± 5%. When atmospheric conditions change, drying time may increase.

storage and transportation. Store 12 months in a closed original package at a temperature of +5 ° C to +30 ° C, protecting from moisture, heat and direct sunlight. If the packaging has an additional “frost -resistant” label, transportation is allowed at a temperature of up to -25 ° C. When freezing the product, thawing at room temperature naturally. After thawing, the product retains all its properties.

precautions. It is necessary to carry out work in a well -ventilated room using personal protective equipment for respiratory organs, vision and skin: glasses, gloves, respirator. If the material gets into the eyes, it is necessary to immediately rinse them with a large amount of water. If the material gets on the skin, remove it with a cotton swab and rinse the contaminated area with a plentiful amount of water. If necessary, consult a doctor. Protect from children.

Composition. Acrylic latex, fungicides, technological additives, antiseptic, water.